Sign in perhaps register 。

　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.　　Pump. In addition,RoselleDrilling fluid slurry pump, the submersible slurry pump is mainly characterized by 'slurry' which is wear-resistant and particle passing.Roselle, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section　　The microcomputer controller displays E: cause: the pressure gauge is disconnected (f= or the input signal is

　　It is an auxiliary means for some on-site monitoring.　　Friends who are more concerned about this issue can dispel their concerns.　　 First of all, we need to know that submersible pumps generally operate in water. In fact, most of the pumps are suitable for conveying some relatively clean media, and their impellers are generally in a closed state. However, one of the media conveyed by sewage pumps mayquality index,　　It is an auxiliary means for some on-site monitoring.　　 When the slurry pump fails to absorb water during operation,RoselleBaigang deep well pump, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　Third, the whole industrial and mining system operates stably, and the operation of the pump will not affect the work of the whole industrial and mining system.

　　Now you know the reason why the pump has air turbidity. In fact, this is a very common phenomenon. You don&#;t have to worry about it. Water pump can transport many things, such as water, oil,RoselleSelf priming non clogging sewage pump, acid-base night and so on. It is a good means of transport.Word of mouth recommendation,　　Be sure to choose a pump that is more suitable for use.　　 If the three-phase current of the submersible sewage pump is large and stable, the submersible pump cannot be started. The reason can only be understood from the submersible pump. Submersible pump bearings may be damaged and the pump may be blocked. The impeller is full of groceries. Submersible pumps shall not be used for sundries, such as those wrapped around the pump shaft　　 the water pipe shall be provided with a gate valve to regulate the pump working point. The valve shall be installed as close to the pump outlet as possible. The pump unit greater than meters shall be provided with a check valve at the pump outlet. In case of sudden shutdown, it is necessary to prevent damage to flow passage components caused by water hammer.Roselle,　　The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining.　　In addition, the water consumption will increase. Therefore, it is necessary for us to choose a suitable water pump.