Sign in perhaps register 。

If the corrosion on the copper surface is found to be slight, it can be erased with linen copper wire, but it is not recommended to apply oil for preservation.Four of the five major application fields of copper plate, copper bar and copper pipe: copper is used as various pipes,In addition, it is very strong, not easy to be corroded, and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected many times in other places. The color change on the outer surface of the copper tube is difficult to control due to environmental factors. To prevent moisture absorption on the surface and core of the annealed brass tube, a constant temperature and humidity packaging room can be built. Packaging in the packaging room can avoid the color change on the outer surface of the copper tube. However it is not easy to control the situation that occurs in the processing process. The cost of ensuring constant temperature and humidity in the whole workshop is too high. The following measures are taken to control the process materials: In the season of high temperature and humidity, during the production and processing of copper tubes, the amount of oil coating on the surface of copper tubes can be increased to form an oil film on the surface of copper tubes which can isolate water vapor and corrosive gases, and prevent the corrosion of the surface of copper tubes; The humidity in the air at night is high, and the outer surface of the copper pipe is prone to corrosion and discoloration at night. Closing the doors and windows of the workshop at night can make the situation worse; After the coil surface is cleaned in the rewinding process, the coating amount of passivation agent on the copper tube surface is increased. After blanking in the rewinding process, plastic bags shall be added to the whole support material to further reduce the contact between the copper pipe and the air and prevent the surface of the copper pipe.Disadvantages of copper pipe As far as copper pipe is concerned, high production cost and high price are its biggest disadvantages. Compared with other pipe fittings, the cost of copper pipe is much higher, and the connection at the copper pipe interface requires high construction technology level.San-Marcos,In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, the overall market has stopped. The market mentality has not changed much sincekend. The price is stable, but some specifications are subject to negotiation, and the negotiation range is about - yuan. The overall rhythm of the market is stable and cold. In the middle of winter, the overall market in Northeast China has entered the traditional off-season, and the overall market has ended with little improvement. All companies are selling goods. The inventory level in Shenyang is very low due to the inventory clearing, and all construction sites have been closed. In addition to the transportation pressure brought by the low temperature, the market was bleak.Although the opening continued the weak trend, the intraday transactions improved, and the prices of some copper bar manufacturers rose. From the specific situation, although the manufacturer feedback that the shipment is average, the mentality is relatively calm, the market inventory is not much, and the manufacturer is not willing to significantly reduce the price. In terms of the market, the transaction of strip steel is better than other steel varieties, and the downstream mainly focuses on callback buying without panic inventory clearing. It can be seen that although the steel market continues to shake, the overall demand for strip steel remains in a good state.

The simplest way is to use copper cleaner. Brass, red copper, bronze, etc. can be used. Oil stains, oxide layers, etc. on the surface can be cleaned with copper cleaner first.Establish the copper pipe pipeline maintenance evaluation specification.In Jiangyin market, slightly lower than the normal level. At the beginning of this week the overall inventory of the current circulation link is about tons, the price gap between Jiangyin prices and those in the north has also been able to correspond to the slightly lower circulation inventory. However, from the perspective of the policy port of the steel plant, the overall production situation of Nangang, Hengrun, Dada, etc. is relatively normal, and the amount of resources in the later period remains stable. The overall inventory of Lecong market remains at about to tons, which is a medium normal level and the recent spot price of Lecong market has a large gap with that of the north.Honesty and mutual benefit,soybean5052 aluminum bar,After : on October , continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel, coking, electric power, cement,soybeanStainless steel coiled plate, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore, in terms of steel plant production, the support of raw materials is weak.The application of copper tube The copper tube is generally used in the heat exchange equipment, and the low-temperature pipeline in the oxygen production equipment can also be used. Some relatively thin copper tubes can be used to transport some pressurized liquids, and can also be used as pressure measuring tubes in instruments; In addition, the copper pipe is relatively firm, unlike other metals, which are easily corroded, so now many water pipes and refrigeration pipes used in buildings will choose to use the copper pipe.After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate and the pressure on the market is relatively small. In Wu an market, according to the data, as of May ,soybean310s stainless steel plate, the total inventory of medium and thick plates in Wu an was close to tons, it reached tons lower in the year, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.Direct material,The copper bar market declined steadily this week, with a decline of - yuan. Due to low pig iron inventory, some steel mills in Jiangxi have resumed purchasing recently, but the purchasing volume is not large. The purchase price of pig iron in Yunnan steel plants was slightly increased to ensure the purchase volume due to the low purchase price of pig iron in the early stage. Recently, the steel market has been in shock and adjustment, and the merchants are unstable. Steel mills in Hebei, Tianjin and other regions have stopped producing pig iron for steelmaking. Now, it is mainly expected to make inquiries. However, due to the lower price of raw materials, the price of iron mills has been lowered.As the inner wall of the pipe rubs with water, its film is damaged, resulting in erosion corrosion. The higher the water pressure, the greater the flow, and the more serious the corrosion.It is said that due to the optimistic future and tight resources, and the price of raw materials has risen, so the iron price has risen. The iron mills have a high enthusiasm for producing steel, so there is not much cast iron resources, and the price has risen. A few steel mills in Tangshan began to purchase a small amount of steel for smelting, and most steel mills are still on the lookout for inquiry. Under the background of increasing cost and gradual release of demand the pig iron market is performing well and is expected to continue to operate strongly in the short term.soybean,The composite method of three production methods of copper tube is also a high-tech production method for this method. It is a copper material containing impurities. Those copper materials, copper alloys and composite copper materials are put together by electrochemical reaction to produce a nanocrystalline copper material, and then the material is purified to produce copper tube materials.The market opened today. Although the performance of Zitong Pai futures was modest the overall market has stopped. The market mentality has not changed much sincekend. The price is stable, but some specifications are subject to negotiation, and the negotiation range is about - yuan. The overall rhythm of the market is stable and cold. In the middle of winter, the overall market in Northeast China has entered the traditional off-season, and the overall market has ended with little improvement. All companies are selling goods. The inventory level in Shenyang is very low due to the inventory clearing, and all construction sites have been closed. In addition to the transportation pressure brought by the low temperature, the market was bleak.If you want to avoid this kind of situation for a long time, you can choose passivation treatment. In this way, not only is the copper surface serious, it can be cleaned under normal circumstances, but it is not a big problem to keep it in the air for one year or more after ultrasonic treatment and immersion treatment, so this effect is very good.