Sign in perhaps register 。

the blank operation point can be supplemented.Mustasari it will also lead to insufficient liquid supply for the pump.　　If the submersible slurry pump cannot be installed and operated,　　 Assembly of water pump: fix the shaft and water inlet joint on the mounting base, fix the impeller and conical sleeve on the shaft with the disassembly cylinder and then install the guide housing and impeller In this way, the upstream casing and check valve are installed in turn.　　First, let&#;s talk about the familiar vertical slurry pumps. Here we refer to ZJL and SP submerged slurry pumps. Strictly speaking, the submersible slurry pump is also a vertical slurry pump, because its axis is basically vertical when it works, but it can be completely immersed in water when it runs, so it is a good choiceTagbilaran　　 After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　 the front and rear bearing glands are equipped with oil seals, the service life of the flow passage parts of the pump is relatively long, saving production costs.

　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.　　If there is a fault, it is recommended that the two pumps be used in turn. When the equipment is in use, it can pretend that a filter screen plays the role of filtration, so as to avoid a lot of impurities entering the equipment and causing pump jamming.Recommendation and consultation,MustasariVertical centrifugal slurry pump,　　 Protective packing of shaft seal the shaft seal pump shall regularly check the sealing water pressure and water volume, keep a small amount of cleaning water flowing along the shaft, regularly adjust the packing gland, check the packing and regularly replace the packing. The shaft seal water pressure and water volume shall meet the above (shaft seal inspection) requirements.　　The balance ring is also disassembled; Then remove the last stage impeller and the key back,MustasariSubmersible slurry pump, and the middle section including the guide vane; in addition, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurry　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.

　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.Installation material list,　　Potential is convenient and flexible. It is easy to operate. It can be operated by a fool who turns on the power supply under immersion; It has a wide range of applications. In many cases,MustasariBooster pipeline pump, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.　　As a display screen, the operation of each fire pump is clear at a glance, and the management is very convenient.　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local placesMustasari,　　A large amount of lubricating oil is stored.　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.