Sign in perhaps register 。

Stainless steel coil is divided into Austenitic, ferrite, martensite,Wollongong 316L stainless steel plate 316L, duplex (ferrite austenite) stainless steel cold rolled coil and stainless steel hot rolled coil.However, the effect of different stages varies with the stainless steel plate and process.Wollongong ,Continuous casting shall be adopted for stainless steel pipe fittings, in combination with out of furnace refining, the production efficiency is significantly improved, and the blank opening process is omitted, which saves a lot of energy consumption.Custom made non-standard pipes Seamless pipe is mainly used in industry. Its surface is foggy and not bright The surface of the slotted pipe is bright, and there is a very thin welding line inside the pipe, commonly known as welded pipe, which is mainly used for decorative materials Another industrial fluid pipe, its pressure resistance depends on the wall thickness and S are resistantZnoimo,The surface treatment methods of stainless steel can be roughly divided into five categories: rolling surface treatment, mechanical surface treatment, chemical surface treatment, reticulated surface treatment and surface treatment. The formed products often include mirror, wire drawing, reticulation, etching, electrolytic coloring, coating coloring, etc.At the same time, it meets the special requirements of complex working environment for pipeline performance. Deformation-d finite element simulation software is used to simulate the three roll cross rolling forming process of double-layer casing with outer layer -n austenitic heat-resistant stainless steel and inner layer cr-ni martensitic heat-resistant stainless steelStainless steel tubes can be found everywhere in our daily use. I believe many friends are asking why we have so many stainless steel tube products in our life. So here are three characteristics of stainless steel tubes to help you better understand.

The ductility of the specimen with larger wall thickness will increase, while the ductility of the specimen with smaller wall thickness will decrease; The ultimate bearing capacity and ductility of the specimen will increase with the increase of wall thickness. In addition, the whole test process is simulated by numerical analysis and compared with the test results,The back side is blocked with a blocking plate for ventilation protection; Only soluble paper or a combination of soluble paper and blocking plate is used for blocking ventilation protection; Use flux cored wire for backing TIG welding.The larger the size, the longer the durability, but the grinding cost is also relatively high.Product range,Flat.When the steel or sample is stretched, when the stress exceeds the limit, even if the stress is no longer increased, and the small stress value when the yield phenomenon occurs is the yield point.It can provide a reference for the new direction of stainless steel surface treatment and has a certain practical guiding significance. In this paper, the corrosion resistance and its mechanism of chemical passivation, silicon treatment and composite treatment of martensitic stainless steel were studied. Comprehensive comparison of the research results shows that the four corrosion resistance tests show that the stainless steel

report