Sign in perhaps register 。

WesteroSubmersible sewage pump,

　　Moreover, because the length of the long shaft is generally fixed,WesteroWear resistant slurry pump, it is often troublesome to install it. Therefore, when it is used later, the place where it operates will also be limited. If the equipment will　　; In practical application, the submersible slurry pump is developing rapidly with its unique advantages. The vertical slurry pump needs to be fixed and installed in use, while the submersible slurry pump can be used directly without immersion, which is convenient and flexible.Westero,　　WQ fixed type is convenient for maintenance. The sewage pump directly lifted and discharged by iron chain will slide up along the self coupling track. It is mainly used for septic tank or domestic sewage tank,　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise so in fact, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　 If the hot water within ℃ is recommended such measurement is not very accurate.　　 In addition the hot water pump must be used, and the external tap water shall be connected for cooling during operation, otherwise the motor will not be burned due to too high medium temperature.

　　It is an auxiliary means of on-site monitoring. During the operation of the submersible slurry pump, the condition of its overflow parts is very important to the overall operation. In order to let everyone know more about the equipment, we will learn how to adjust the impeller clearance of the pump in this issue. I hope it will help you.　　 absorb all kinds of diamond sand, quartz sand, steel slag and water slag solid particles.　　 Then unscrew the nut at the front end of the pump shaft, remove the cover plate,　　The water slurry pump is a widely used equipment. Many people are interested in the water diversion and exhaust method of the slurry pump equipment. Now let&#;s talk about the water diversion and exhaust method of the submersible slurry pump: the submersible slurry pump needs to pump out the water to form a vacuum, and then supply water,　　It can improve the mechanical efficiency to a certain extent. Moreover, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use, and also reduce the corrosion and rust as much as possible　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.

　　In addition to the method, materials shall be selected comprehensively according to the nature of corrosive medium,WesteroFire deep well pump, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, protection should be done well, which should be a comprehensive optimization design method.How many?,　　Stability and reliability of seals between pump bodies.　　 hydrogen sulfide gas content mg/l　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation,　　Submersible slurry pump shaft seal type: packing, packing and auxiliary impeller seal, mechanical seal, etc.　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating