Sign in perhaps register 。

the oxidation method is the most. Because as long as the metal copper is oxidized by the anode and the copper ion of the anode is attached to the tube material, the copper tube can be produced. Thisthod is also the most common method to produce copper materials. It has not only been used for a long time but also has a mature technology, which is to produce copper tubes through oxidation reaction. This production method is the main production method of copper tubes in China.In Jiangyin market another distribution center, slightly lower than the normal level. At the beginning of this week, the price gap between Jiangyin prices and those in the north has also been able to correspond to the slightly lower circulation inventory. However, from the perspective of the policy port of the steel plant, the overall production situation of Nangang, Hengrun, Dada, etc. is relatively normal, and the amount of resources in the later period remains stable. The overall inventory of Lecong market remains at about to tons, which is a medium normal level, and the recent spot price of Lecong market has a large gap with that of the north.Qiuming,The storage and transportation of copper tubes in summer should also be paid attention to when controlling the surface of copper tubes.At present, the fundamentals faced by the domestic copper bar market are still mixed. On the one hand, the market supply is expected to shrink, but on the other hand, the northern market has entered the off-season of demand, and the market s expectation of future demand is pessimistic. In the short term, domestic steel prices will enter the operating track of range consolidation. To sum up, considering the current situation of demand and inventory in the steel market it is difficult for the steel market to make a breakthrough. As the th National Congress of the Communist of China is approaching, environmental protection phenomena such as steel mills are still going on, and black series speculation is still taking place. But personally, the fluuation range of the market in this region is limited, and businesses can operate flexibly on a short-term basis, and the shipment transaction is * * *.Bauchi,The price of pig iron market rose by - yuan this week, and the transaction was fair. With the increase of coke price, Henan, Liaoning, with the gradual release of downstream demand, the inventory of iron plants is not large, and iron plants have successively raised their prices. There are few iron foundries in Shandong, Jiangsu, Hebei and Shanxi, and the inventory remains low. As the coke price rises and the cost increases, the price of iron foundries rises again.Four of the five major application fields of copper plate, copper bar and copper pipe: copper is used as various pipes, pipe fittings and decorative devices in the construction industry.In the middle and late ten days,QiumingT2 copper bar, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, and the continuous rise of inventory led to the empty market mentality.

Copper pipe has the characteristics of, and is the choice for the installation of water pipe, heat supply and refrigeration pipe.{} The copper pipe welding can be divided into soft welding and hard welding. The soft welding temperature is lower than ℃, and the hard welding temperature is higher than ℃. Hard welding is usually used for silver, gold, steel, copper and other metals. Its welding points are much stronger than soft welding, and its shear strength is - times that of soft welding.Insert the pipe into the top of the bayonet,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.Design brand,The room temperature tensile strength of the annealed red copper sheet is ~ kgf/mm, the elongation is ~%, and the Brinell hardness (HB) is ~According to * * new data, in September , China s imported iron ore * * * broke through the million ton mark, reaching million tons, a record high; From January to September, China s iron ore import increased by % to million tons and the annual import volume is expected to exceed billion tons. However, judging from the shipment of imported ores after the National Day, due to the rapid declinecline in iron ore prices, the iron ore price index once fell below $, which reduced the enthusiasm for the shipment of imported ores. In addition, environmental protection inspection has become stricter, and the supply of some domestic mines has been greatly affected. The current operating rate of domestic mines is percentage points lower than the previous peak, which is likely to decline further in the future.So far as the storage method of copper materials is concerned, we should properly keep the copper products we buy, extend the service life of copper and ensure its performance to avoid unnecessary losses.

Because of the characteristics of copper itself,Qiuming316L stainless steel coiled plate, it is very easy to rust and corrode in places with high ambient humihumidity. If we often use it, the problem will be smaller, but if it is placed for a long time the copper will be damaged. Many people do not know how to treat the copper surface? Now let the staff answer for you.knowledge,If you want to avoid this kind of situation for a long time, you can choose passivation treatment. In this way, not only is the copper surface serious, it can be cleaned under normal circumstances, but it is not a big problem to keep it in the air for one year or more after ultrasonic treatment and immersion treatment, so this effect is very good.It is applicable to the removal of thin liquid oil stain and light rust and the generation of phosphating film with certain corrosion resistance. See Table for example of formula and operating conditions. Table Degreasing, rust removal, phosphating and passivationIn consideration of the above factors, more and more steel plants have stopped production since October, and the production limit in Wu an and Tangshan heating seasons has been advanced. In addition, the formal implementation of production limit in & quot; +& quot; urban heating seasons after November by steel enterprises, the demand for iron ore in the future is likely to further deteriorate. The iron ore inventory of the steel plant is relatively high,Qiuming5083 aluminum bar, the fourth quarter is generally the peak period for the shipment of imported ores. Although the production of domestic mines has been reduced due to environmental protection, the quantity of * * * is relatively limited. In general, the short-term iron ore market may lack upward momentum.Qiuming,Disadvantages: low output, high production cost and high price. Extrusion copper tube process is a stable and excellent copper tube production method at home and abroad at present. Only the copper tubes produced by this process are more suitable for the field of heating and ventilation, which is the development direction of copper tube industry in the future.Copper tube is a kind of nonferrous metal tube, and is solid and corrosion resistant. It will not crack when compared with the ambient temperature, so it becomes the first choice for modern contractors to install the water pipe, heat supply pipe and refrigeration pipe in all residential commercial houses.The copper tube shall be heated and welded first, and then the joint shall be heated until the heated part turns dark red. At this time, when the filler metal contacts the tube, the filler metal shall melt.