Sign in perhaps register 。

　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling the motor temperature will rise, so it is easy to burn out the motor.Samsky,　　The rotation direction of QW (WQ) submersible non blocking sewage pump after connection is counterclockwise from the water inlet. Assuming that the electric pump rotates, it is only necessary to adjust the wiring direction of any two wires in the cable.　　What?Randfontein,　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows　　 First remove the pump from the engine.

　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　 WQ submersible sewage pump adopts a unique single or double vane impeller structure, which greatly improves the sewage passing capacity, and can effectively pass through times the diameter of the pump and solid particles with a diameter of about % of the diameter of the pump.　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.Quality improvement,　　The water pump can be used to transport and pressurize clean water without impurities, such as apartment, residence,SamskySubmersible sewage pump, villa water supply, factory water supply, water supply system,SamskyCentrifugal slurry pump, drinking water system and water treatment. In short, there are many uses.　　It is longer and saves production cost. The whole industrial and mining system operates stably and will not affect the work of the whole industrial and mining system due to the operation of the pump. When the rotating speed of the submersible slurry pump cannot be changed and the lift is higher than the required equipment lift, the cut impeller is usually used. The cut is　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise so in fact, such measurement is not very accurate.

　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speedQuality Assurance, which will cause abnormal sound inside the pump it is likely that the equipment may have air infiltrating into it when absorbing water, and then at the same time, the impeller is damaged or the impeller is damaged　　. (when the liquid flows back, it will generate huge reverse pressure and damage the pump)　　Occurrence of personal injury accident. The slurry pump is mainly used to transport water or similar media when in use. It can also be regarded as a common pump in our life,　　After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area,SamskyWear resistant slurry pump, so there will be no buried pump when it is used. However, replace it with a new one.　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.