Sign in perhaps register 。

Precautions for solid wood floor installation : do not use the fixing method of wooden wedge and nail.Floor leather (also known as coiled floor), a new type of flooring material, belongs to plastic products. It is one of the indispensable floor materials for modern room decoration. It has a thickness of more than mm and a wear-resistant layer of more than . Generally, glass wire with good flatness or double primer is used.Plastic floor leather belongs to soft floor. It is a floor roll produced by coating or calendering on sheet continuous substrate with polyvinyl chloride resin as the main raw material and appropriate additives.Advantages of floor leatherKankaanpaa,Moreover, the formaldehyde in the floor mainly comes from the adhesives and coatings used in production.In order to improve the hardness of the board and have the effect of insect prevention and anti-corrosion, most artificial boards use urea formaldehyde resin as the adhesive. The main component is formaldehyde, and residual formaldehyde is inevitable.The environmental protection grade of domestic flooring is divided into E, E and E Only the flooring reaching grade E has a formaldehyde emission of no more than mg/l, which meets the requirements of national standards. Ultra light and ultra-thin, SPC floor has a thickness of about mm-mm and light weight which is less than % of ordinary ground materials. It has incomparable advantages in stair bearing and space saving in high-rise buildings. At the same time, it has special advantages in the reconstruction of old buildings.Funei, Produce gene mutation effect.When assembling the solid wood floor, do not be too loose or too tight.The assembly relaxation shall be reasonably arranged according to the temperature of the indoor environment. The assembly relaxation will produce a large gap with the shrinkage of the floor.The assembly is too tight and the floor is arched when it expands. Do not scrape or scratch the floor surface with sharp tools.

The laminate floor is composed of wear-resistant layer, decorative layer, base material and balance layer.The wear-resistant layer, decorative layer and balance layer are manually printed,KankaanpaaHall wood floor modeling, and the base material is made of fast-growing forest materials. The cost is lower than that of solid wood flooring. At the same time, it can be produced on a large scale, and the relative cost performance is high.Due to the different base materials, the price difference is obvious, and there is more room for customers to choose, which is suitable for people at all levels.During the test of solid wood floor in the factory, if some wood floors are found to be warped or falling off, the wood floor shall be taken out immediately, glued and tamped.Fourth,KankaanpaaHow wide is the floor leather, it is mainly the veneer thickness (decorative board thickness). The multi-layer solid wood floor has ,-, and the new three-layer solid wood floor has , mm.Customer first,The water resistance is reflected by the water absorption thickness expansion index. If the index value is high the water resistance is poor, that is, it is easy to cause size change in humid environment.Must not listen to the misleading such as waterproof floor, only moisture-proof floor, no waterproof wooden floor.In order to reduce the cost, SPC latch floor with extremely poor quality and low price is adopted,KankaanpaaHow about composite floor, which has poor stability and large thermal expansion and cold contraction.The loss is caused by the 'general paving method'.In order to prevent local fading due to frequent sunlight exposure, it is best to hang curtains to turn direct light into diffuse light, which is conducive to prolonging the service life of the floor. Pay attention to the fact that hard substances such as metal sharps and shoe staples are easy to scratch the surface of the worn lacquer cloth. Avoid cigarette butts,In case of indentation, it is difficult to remove. Although the ground lacquer cloth is flame-retardant and self extinguishing, it will decompose harmful gases at high temperature, pursue foreign goods

SPC floor is an excellent raw material with the advantages of wear resistance, durability, low carbon and environmental protection.It is widely used in various indoor places.Including diagnosis and treatment sports culture, colleges and universities, culture and education, kindergartens, business services, offices, etc.The shadow of SPC floor can be seen.Direct material,Again, ask what kind of material is the veneer on the floor (because the prices of different materials vary greatly).How to buy solid wood composite flooring? Never soak the floor with water during use. If there is an accident, mop the floor with a dry mop in time.Kankaanpaa, Green environmental protectionFoot feelWhen choosing wood flooring in , customers attach great importance to quality.Although the solid wood floor is good, the maintenance is very complicated.In , all stores released high wear-resistant solid wood flooring.It is said that this kind of floor not only has the characteristics of high wear resistance and general solid wood floor but also has strong coating adhesion, high definition, good corrosion resistance, strong waterproof, not easy to crack and paint.