Sign in perhaps register 。

On October , according to the Economic and Information Commission oong Province, at the end of September , Shandong Province had resolved the overcapacity of million tons of pig iron and million tons of crude steel, and all the de capacity equipment had been shut down and withdrawn. On October , the Development and Reform Commission of Handan City released the Plan for Handan City to Eliminate Excess Iron and Steel Capacity. Statistics show that the iron making capacity of Handan in was million tons and the steel making capacity was million tons.For small diameter pipes, when using filler metal, the length of filler metal is allowed to be equal to the diameter of the pipe, which is enough to fill the weld crater. One of the five major application fields of red coppr plate T, red copper bar and red copper tube: copper is the most widely used and used in the electrical and electronic industries, accounting for more than half of the total consumption. Used for various cables and wires, motors and transformers, it is used to manufacture industrial valves and accessories, instruments, sliding bearings, molds, heat exchangers, pumps,Irish root1060 aluminum bar, etc.Irish root,Brass tube Soft copper tube is called hose, and the tube is used to replace the hard one, so soft copper is widely used. Besides being in a straight line, you can also have coils and coils in the form of long advantages. When used at the connection point is long, cut according to the free length, so as to avoid leakage of copper tube brass welding. Soft copper tube requires local bending of air conditioner, refrigerator, and mechanical oil tube.pper tube Copper tube is easy to heat because of its light weight, and it can also be used normally at low temperatures.If the corrosion on the copper surface is found to be slight, it can be erased with linen copper wire, but it is not recommended to apply oil for preservation.Wa,The simplest way is to use copper cleaner. Brass, red copper, bronze, etc. can be used. Oil stains fingerprints, oxide layers, etc. on the surface can be cleaned with copper cleaner first.[] Welding process of copper pipe Clean the end and seven ports of steel pipe with steel wool. Do not use abrasive cloth or abrasive paper to clean, because it will affect the clean interface and result in poor welding effect.However, it is difficult to change this situation too much in the short term. It is expected that the domestic strip steel price will mainly rise in the short term. It is reported that in order to pursue profits, Tangshan Iron and Steel Group Co., Ltd. is currently increasing the supply of hot coils. It does not rule out that more steel mills in the future are inclined to one end of the plate in pursuit of profits, integrating cold resistance the price may still maintain a narrow range of shock operation pattern.

Advantages of red copper tube Durability: copper has stable chemical properties, heat resistance, pressure resistance, corrosion resistance and fire resistance, and can be used in different environments for a long time.As the copper pipe is easy to process and connect, it can save materials and total cost, stability and reliability, ground heating is not only a comfortable heating method, but also a symbol of modern life quality. More and more houses, public buildings, sports facilities, industrial facilities and other places begin to use ground heating radiator, which is an important part of ground heating. Due to the corrosion resistance of copper, copper tubes are selected as the main material of radiator in many places.Application process,The conductive production of copper tube is the latest method for this method. It is the production of nanocrystalline copper materials with conductivity. Because this raw material is very special, it is a copper material produced by using nanotechnology, and copper ions can be separated by conductivity, so that copper tubes can be produced with the separated copper ions. This method is very complex, requires high technology and new equipment, so only advanced foreign countries can use this production method.After : on October ,Irish root40Mn2 alloy steel plate, continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel, coking, cement, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore in terms of steel plant production, the support of raw materials is weak.The copper tube shall be heated and welded first, and then the joint shall be heated until the heated part turns dark red. At this time, the filler metal shall melt.

First of all, we should set up a warehouse. The temperature in the warehouse should be generally kept at - ° C, while the humidity should be normal. The room should be kept ventilated.agent,Overview of three production methods of copper tube Copper tube is a very important material for copper materials. There are many ways to complete the production of this copper tube. For copper pipes, the following three methods are generally used to produce materials. The copper tubes produced by these three methods are not only very good in performance, but also very convenient to operate. There are three production methods for copper tube, so what are the three production methods for copper tube?Copper pipe has the characteristics of firmness and corrosion resistance, and is the choice for the installation of water pipe, heating pipe and refrigeration pipe.Safe and reliable: copper pipe combines the advantages of metal pipe and non-metal pipe. It is harder than plastic pipes and has the high strength of ordinary metals (the strength of cold drawn copper pipes is equivalent to that of steel pipes with the same waess); It is also easier to bend than ordinary metals, has good toughness and high ductility, and has excellent anti vibration, anti impact and anti frost expansion properties.Irish root,Do not store too many other products, especially other acid materials and alkali materials in the warehouse to prevent mutual reaction.In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market,Irish root40cr alloy steel plate, high production cost and high price are its biggest disadvantages. Compared with other pipe fittings, the cost of copper pipe is much higher, and the connection at the copper pipe interface requires high construction technology level.