Sign in perhaps register 。

The L distance depends on the selected wall mount model.In addition to ground protective fences, a half height middle crossbar, and a toe board at least mm above the ground.Bitom,After the limit switch is activated, only professional personnel can restore the movement of the suspension cage; Limit switches and travel switches should not share the same triggering element; Limit switches should be either suspended orThe scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform,BitomElectric hydraulic platform elevator, and high bearing capacity,The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.

Mechanical devices controlled by cage movement should not be used to open or close the landing door.Platform.The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, improving the utilization rate of the wellbore area.Online consultation,Mechanical devices controlled by cage movement should not be used to open or close the landing door.Horizontal lead screw mechanical electricityThe verticality of the guide rail frame should meet the requirements of the specifications.

Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature dropsMarketing Department,When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.Greater than .s; When the hydraulic buffer is used, the oil level shall be checked, and the action of the hydraulic buffer shall be monitored by the Electrical safety switch. When the hydraulic buffer is compressed,BitomMicro electric hydraulic elevator, the cage shall notIt is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations making high-altitude operations easierBitom,Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.The use of standard section connecting bolts should comply with the user manual and specification requirements.