Sign in perhaps register 。

　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.Cologne, which can make the pump operate safely and continuously for more than d~ hours.　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.Boras,　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even,CologneSmall deep well pump, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation without noise and vibration, and the site is cleaner.　　 First of all, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than %, then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil, which leads to accumulation

　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　 No maintenance: if it is not used continuously after startup, the submersible pump will rust and cannot be started. If it is not used for a long time, do not immerse it in water for a long time. Put it into clean water and run it for a few minutes to clean the mud inside and outside the pump.　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.Good reputation,　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.　　The development of submersible slurry pump is to adapt to increasingly complex working conditions, facilitate users to use,CologneFire deep well pump, and its use mode is more flexible. And it fills a part of the gap in the application of slurry pump. When the submergence depth is deep and there is no better slurry outlet, that is, in the traditional slurry pump　　In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is

　　Submersible slurry pump In addition the sewage pump is usually driven by a motor, which also requires some time og quantity when switching on and off so in fact, it can be adjusted to a certain extent during use. The submersible slurry pump needs to use a line when in useHonesty is the foundation,　　No matter what type of slurry pump you need,CologneVertical heavy-duty slurry pump, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　The microcomputer controller of the water pump control cabinet displays E: cause: the parameter of the microcomputer controller is edited incorrectly.　　Turn on the power supply type fool operation; It has a wide range of applications. In many cases, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.Cologne,　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.