Sign in perhaps register 。

However, it is difficult to change this situation too much in the short term. It is expected that the domestic strip steel price will mainly rise in the short term. It is reported that in order to pursue profits, Tangshan Iron and Steel Group Co. Ltd. is currently increasing the supply of hot coils. It does not rule out that more steel mills in the future are inclined to one end of the plate in pursuit of profits, or to lay hidden dangers for the decline. As far as tomorrow is concerned, the price may still maintain a narrow range of shock operation pattern.When welding, just add enough filler metal to fill the capillary gap. Too much filler metal will only form a ball at the bottom of the joint or run into the pipe.Mace,For the deposited copper tubes, do not open the outer packaging as much as possible.If you want to make the copper surface become bright again,MaceBronze tube, you can polish it with copper point solution. It can not only make the copper surface brighter, but also quickly remove the rust and oxide layer on the copper surface to restore the luster of the copper itself.Affery,Remove the flame. If the filler metal does not melt,MaceRed copper bar, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe the welding flux must have a degree of corrosivity, the price of domestic medium and heavy plates fell sharply. As of August , the price center of ordinary carbon boards in leading cities had dropped to , affected by the macro bad news, and the recent poor performance of fundamentals, the market mentality turned to pessimism, and some traders shipped at low prices. The market inventory rose, the inventory pressure was high, the stock shortage phenomenon disappeared, and the market transaction atmosphere was cold, the demand performance continued to decline, and the spot price fell under pressure.The blowpipe shall be perpendicular to the lead pipe during welding and the flame shall be moved continuously to prevent local overheating and the flux from carbonizing before filler metal is added.

Insert the pipe into the top of the bayonet,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.Dissolved oxygen in water is a major factor in copper pipe corrosion.It is said that due to the optimistic future and tight resources, some iron plants do not take orders temporarily. The steel mills in Liaoning have increased their enthusiasm for purchasing steel. The iron mills have delivered well, and the price of raw materials has risen, so the iron price has risen. The iron mills have a high enthusiasm for producing steel, so there is not much cast iron resources, and the price has risen. A few steel mills in Tangshan began to purchase a small amount of steel for smelting, and most steel mills are still on the lookout for inquiry. Under the background of increasing cost and gradual release of demand, the pig iron market is performing well and is expected to continue to operate strongly in the short term.Installation works,On October , according to the Economic and Information Commission oong Province, at the end of September , and all the de capacity equipment had been shut down and withdrawn. On October , the Development and Reform Commission of Handan City released the Plan for Handan City to Eliminate Excess Iron and Steel Capacity. Statistics show that the iron making capacity of Handan in was million tons and the steel making capacity was million tons.Four of the five major application fields of copper plate, copper bar and copper pipe: copper is used as various pipes pipe fittings and decorative devices in the construction industry.After : on October , continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel,Mace20CrNiMo alloy steel plate, coking, electric power, cement, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore, in terms of steel plant production, the support of raw materials is weak.

On the other hand, in the steel plant the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low, but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However, with the decline of black futures, the market transaction volume shrank significantly. In addition, the inventory pressure was high, traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.Analysis project, red copper, bronze, etc. can be used. Oil stains, fingerprints, oxide layers, cracks and other damages.The main force of iron ore futures closed at in The closing price of the day today was the same as that of the previous trading day, including * * * * , * * * , settlement price , trading volume , and position volume . The intraday tradg volume decreased by compared with the previous trading day, and the position volume decreased by compared with the previous trading day. After six consecutive days of downward adjustment, there was a rebound at the bottom of the session today, but it was corrected again later, and the closing was flat.Mace,The copper tube shall be heated and welded first, and then the joint shall be heated until the heated part turns dark red. At this time, when the filler metal contacts the tube, the filler metal shall melt.It is said that due to the optimistic future and tight resources, some iron plants do not take orders temporarily. The steel mills in Liaoning have increased their enthusiasm for purchasing steel. The iron mills have delivered well, and the price of raw materials has risen, so the iron price has risen. The iron mills have a high enthusiasm for producing steel, so there is not much cast iron resources, and the price has risen. A few steel mills in Tangshan began to purchase a small amount of steel for smelting, and most steel mills are still on the lookout for inquiry. Under the background of increasing cost and gradual release of demand, the pig iron market is performing well and is expected to continue to operate strongly in the short term.First of all, we should set up a warehouse. The temperature in the warehouse should be generally kept at - ° C, while the humidity should be normal. The room should be kept ventilated.