Sign in perhaps register 。

The electroless plating Pd film with uniform film and good adhesion was obtained by electroless plating PD process. The surface morphology and composition of electroless plated Pd film on L stainless steel were characterized by electron scanning microscope (SEM), energy dispersive spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS). immersion test Stress relief treatment. Stress relief treatment is a heat treatment process to eliminate the residual stress of steel after cold working or welding. Generally, it is heated to ~ ℃ for tempering. For steels without stabilizing elements Ti and Nb, the heating temperature shall not exceed ℃, so as to avoid precipitation of chromium carbide and intergranular precipitationFinland,Polishing at present, stainless steel products are generally polished in the production process, and only a few products such as water heater and water dispenser lining do not need polishing. Therefore, this requires good polishing performance of raw materials. The main factors affecting the polishing performance are as follows: . Surface defects of raw materials. asThis is also one of the reasons why some consumers often encounter product oxidation when using stainless steel products. Some consumers operate improperly in product use and maintenance, especially some stainless steel pipe products used in food and chemical equipment industryAqsu,Number of times.It is well known that the stainless steel plate bellows compensator is actually very different from the torsion free tube compensator. The root cause of this difference is itCold rolled oriented silicon steel strip (sheet) with iron loss value of and thickness of .mm is now represented as q.

The surface crack at the weld toe of the welded joint is evaluated by SINTAP. Under the given original crack size and load conditions, the evaluation points fall within the scope defined by the evaluation curve, indicating that the structure can be used safely under the given load. At the same time it is possible toIf rust is found on the surface of stainless steel plate, the surface can be brushed with stainless steel plate wax. This product is specially used for rust prevention treatment of stainless steel. After brushing the wax for a period of time, polish, polish and clean it, and then clean the wax on the surfaceIt is a kind of low carbon high alloy stainless steel. Because the nickel content in its composition is less than % the steel contains ferrite austenite structure, so it is called duplex stainless steel.Sales Department,The side was sealed with adhesive tape (see Table ), which successfully solved the above problems.Bottom of the valley. Only inFolding editing the principle of this paragraph when the stress of steel or sample exceeds the limit, even if the stress does not increase any more, but the steel or sample continues to have obvious plastic deformation, this phenomenon is called yield, and the small stress value when yield phenomenon occurs is the yield point. Let PS be flexure

For the oxidation phenomenon of steel products caused by human beings,Finland405 stainless steel sheet, it is necessary to have correct product use knowledge and carry out reasonable and effective maintenance and maintenance regularly, so as to reduce the oxidation phenomenon caused by improper human use.Administration, in which ferrite accounts for % - %. This dual phase structure is not easy to produce intergranular corrosion.Finland,Finland316 high quality stainless steel pipe,The mechanism of stainless steel rust prevention is that alloy elements form a dense oxide film to isolate oxygen and prevent further oxidation. So stainless steel is not & ldquo; Stainless & rdquo;.Enhancement. The composite treatment of citric acid passivation and acid silicon system treatment has excellent corrosion resistance and environmental protection characteristics, and is expected to replace the traditional dichromate passivation treatment. According to the film weight test results, the composite treated samples were passivated with citric acid and then treated with acid silicon systemMoreover