Sign in perhaps register 。

The list of materials for making landing doors is as follows: Table : List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.When the landing door is closed, the full width of the lifting passage opening should be covered.Scarisco CARMENA,When charging, it is necessary to charge it in a timely manner. When the equipment is used for about months (according to the actual frequency of use), it is necessary to add grease to the rotating parts once; Regularly inspect the working status of the pin shaft of the fully self-propelled electric elevator every month, and if any pin shaft is foundDuring the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, and record the inspection results.Tulu Bolo,Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.

The hydraulic oil forms a certain pressure by the vane pump, throttle valve,Scarisco CARMENAElectric elevator 8 meters, hydraulic control one-way valve, and balance valve causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve,The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, improving the utilization rate of the wellbore area.Installation and dismantling personnel and drivers should hold certificates to work.Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, scissors, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.

The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.Industry management,When the landing door is closed,Scarisco CARMENAElectric brick elevator,Scarisco CARMENAHand push electric elevator, the full width of the lifting passage opening should be covered.It is strictly prohibited to use travel limit switches as switches to stop operation.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.Scarisco CARMENA,Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Horizontal lead screw mechanical electricity