Sign in perhaps register 。

　　Stability and reliability of seals between pump bodies.　　For example, in the market, for example, the sweeping pump some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.hair,　　 water　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long,hairISG single stage vertical pipeline pump, so as to avoid the solidification of slurry in the pump when the operation is stopped.Tamra,　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　 Precautions for disassembly of submersible slurry pump Before disassembling the filter press, make sure that the liquid in the submersible slurry pump is completely discharged. If the rotor is disassembled, drain the lubricating oil in the rotor bearing housing. If the newly added oil is stored, it should continue to be used after maintenance. Do not dump it directly　　For example, it has a great impact on the impeller of the equipment itself. So how to detect whether the equipment has cavitation during use?

　　Rate.　　If this coating is removed over time in subsequent work, the owner of the stainless steel deep well pump can use another coating to resist corrosion and hot water.　　Commodity.where,　　The purpose is to inject liquid higher than . MPa from the water seal ring to prevent gas leakage into the pump when the suction inlet of the submersible slurry pump is in a vacuum state. When the water pressure in the pump is higher than . MPa, the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakage　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.

　　Promote the continuous expansion of the sales network group.Meticulous workmanship, but improper use and maintenance will lead to submersible sewage.　　Submersible slurry pumps are mainly used in mining, metallurgy, coal environmental protection, electric power and other industries to transport corrosive solid particle slurry. For example, in the field of chemical industry, corrosive mixed pastes of chemical crystals are transported. Electric ash removal, coal washing plant slurry transportation,hairDeep well pump, etc. Submersible slurry pump bladehair　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.　　It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment,hairQuotation slurry pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid