Sign in perhaps register 。

　　 Then reinstall the equipment on the engine and install the rubber hose.　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure, breakage, etc.Petapa,PetapaWQ submersible pump parameters,　　The specific treatment methods are as follows: first, check the power supply of the power supply to see whether the connector of the power supply is secure, whether the switch is tight,PetapaCentrifugal slurry pump, and whether the fuse is intact. In case of short circuit, short circuit, fuse burnout and other problems, it shall be repaired in time. If it is not a power problem, check the water pump　　In fact when the submersible slurry pump is blocked during use, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself, so it is also a reminder that we are using it tooGranada,　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.　　 bind the exposed copper wire to the cable core evenly, heat it with an electric iron, and infiltrate tin evenly.　　In addition to the main impeller inside the equipment, a set of impeller for mixing will be added at the bottom of the equipment, so that some mortar slowly settled inside the equipment can be mixed with water to become a flowing medium, so that the equipment can be used without its

　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, and the user needs to connect it separately during installation. If the connection is wrong, it will seriously affect the normal operation of the pump, and then connect the motor to the ash pump. There is a removal ring at the journal. This device can prevent the impeller from reversing.　　It is an auxiliary means for some on-site monitoring.quality standard,　　The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining.　　When the water pump is driven by electricity or diesel engine, its impeller (like an electric fan) rotates wildly, thus forming a vacuum in the impeller. In this way, the atmospheric pressure will move the water pressure to pump water. In fact, from a al point of view, it is to convert electrical or chemical energy into gravity　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!

　　Water flow into the bearing damages the bearing.Superior quality,　　So it has a process of water diversion and exhaust. There are usually two ways to inject water into equipment. One is to directly inject water into the pump chamber, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.　　 before starting check all circuits and switches to see if their wiring is correct and reliable, and check whether the motor running direction is correct. If the above problems are not found, it can be started　　In this way a smooth surface can be formed on the surface.Petapa,　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, it is necessary for us to choose a suitable water pump.　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.